Basic Setup
Last updated
Last updated
The GitBook based NorthstarWiki has been replaced in favour of the NorthstarDocs where this wiki has been integrated.
Check it out here: https://docs.northstar.tf/Wiki/
The same page on the new wiki should be located here: https://docs.northstar.tf/Wiki/installing-northstar/basic-setup
Head over to the installer page and pick one of the existing installers. All of these take care of both installing and updating Northstar.
If you prefer to avoid any additional installers and know what you're doing, check out the guide for manual installation:
Should you notice any issues/warnings/errors while running Northstar, check the troubleshooting page.
You can launch Northstar via Steam, Origin, or EA using launch options.
If Northstar doesn't appear to be installed, or you have issues entering the lobby, try running vanilla files. It's hard to say what VPK mods could cause issues with Northstar at the moment, so it'd probably be easiest just to try running unmodded.
Northstar can also be launched through Steam or Origin using the "add a game" feature. This allows you to register any .exe as a game. To set up Northstar, navigate to your Titanfall 2 folder and choose NorthstarLaucher.exe.
Steam can be configured to prompt for starting either Northstar or vanilla when Titanfall 2 is launched. This example uses SteamEdit, however another appinfo.vdf/packageinfo.vdf editor can be used.
Download SteamEdit, extract it, and run SteamEdit.exe. Select Titanfall® 2 from the dropdown.
Click on Edit Launch.
Click on Add New.
Enter a name for Northstar and enter NorthstarLauncher.exe as the executable.
Click OK to close LaunchEditor, and click Save & Refresh to save your new configuration and restart Steam.
Launching Titanfall 2 will now display a prompt for vanilla and Northstar.
Install instructions for Linux and Steam Deck can be found here
